Fairy Princess Glass

Materials:

#15-0200 Armour Etch Glass Etching Cream.

#21-1676 Over N Over stencil-FairyTales

#08-9606 Brushes.

#08-9999 Gloves.

#08-9415 Masking tape.

Paper towels.

Pedestal glass

Directions:

1. Wash the glass in hot, soapy dish water. Dry well before applying stencils

2. Place the Princess stencil at an angle across the center of the glass (see picture for placement). Apply the cluster of three stars to the left of the first stencil and the cluster of two stars below. Place the fairy to the right side near the rim of the glass.

3 .Surround the stencils with masking tape, overlapping all edges, cover entire side of the glass

4. Put on the rubber gloves. Load the brush with Armour Glass Etching cream. PAT the etch cream onto the stencils (do not brush it on) until each is thoroughly covered with a 1/4 inch of cream. View the directions and How To Videos HERE.

5. Leave cream on for 5 minutes

6. Holding glass upside down so no water or cream gets inside, rinse off all of the etching cream under running water. Remove stencils and rinse again. Pat the stencils dry and return them to the carrier sheet.